FocusCanada Forums

Full Version: One Of The Nicest Turbo Setups I've Seen...
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
On a focus that is....

[Image: water1.jpg]
[Image: turbo4.jpg]
[Image: turbo3.jpg]
[Image: turbo2.jpg]
[Image: turbo1.jpg]

[Image: man3.jpg]
[Image: man2.jpg]
[Image: man1.jpg]
[Image: intercooler1.jpg]
Thats is very clean but like DP was mentioning to me, that piping is only tacked right now, still none the less....very sexy.
VERY nice!
Schweeet!
I didn't think those were finished welds.
Yeah it doesn't look finished but when its all done its going to look real clean.

A nice touch is the stepped stainless 90 degree bend going ot the throttle body. Most would have just used a 90 degree silicone coupler :P

I saw that too.


Nicely done.
I'm gonna take on the boo-birds for this, but WTF with the exhaust pipe routing?

It just looks way too complicated... and obviously the battery and other stuff was removed / relocated.

The header may look complicated but having equal runner lengths is the correct way to do things. The stepping is also quite mild, so its all good.

Yeah relocating the battery is an easy move and gives sooo much more room for a nice setup. Why spend hours figureing out how to route stuff when its at most $90 for a battery relocation kit.
I agree completely with the battery relocation as a handling upgrade / improvement, but I totally zoned on equal length being good for F/I. Meesa N/A guy, didn't know that :P

I'm sure it will haul ass.
that is probably one of the best locations for the turbo .. get it out in the open instead of trying to cram it all between the block and the rad.

that pretty close to where its mounted in the wrc focus if my memory serves me right ..

whos car is that?
[Image: engine1_hi.jpg]
You memory is pretty good. :rolleyes:
^^^ i had thought the same thing, its just a bit lower

very clean job.. i love stainless... its time to POLISH lol j/k that would take forever