FocusCanada Forums

Hey Guys, I'm getting ready to install my voltage gage for my system and i'm wondering which wires should i tap for illumination, and Ignition (switched power) i'm probably going to mount the gages in the a-pillar. so i really dont want to run the wires all the way to behind the stereo. even though it would seem the best way to gaurantee switched power.

I tapped my park lights for illumination, that way if you're running just parks or headlights your gauges are lit.

For ignition, you can pick pretty much anything.

where did you tap your park lights? on the switch?

bump... doing this later today. where did everyone tap their parking lights? which wire on what O2 sensor should i use for the a/f signal.


Thanks