FocusCanada Forums

Anyone done this yet?
I need to find out what to do with my old air vent tube as the euro one doesn't have a location for it.

Here's a pic of the tube I'm talking about(little black one on the left).


maybe there's a way to retro fit it some how?

I had the same problem when I installed my billet fuel door....
I think I just zip tied the hose to the filler neck and left it like that

Thanks for the idea, I might grab a stock one from the wreckers and see if I can chop and remould to work, if not I'll prbably just zip tie it.

what's the purpose of that vent??

I have the euro locking filler flap on my ZX3, I did not have a spot to connect that hose, so I just zip tied it to the filler neck like everyone else did.

It's just a vent hose, when you pour gas into the tank, the air in your tank needs to escape somewhere, otherwise a fill up will take you an awfully long time.

If everyone else is doing it than so shall I

Paolo did you take the inner fender liner off to install it?
Or is it accessible to work on with out taking it off?

I do not remember, as it was a long time ago, like 6-8 years ago.