FocusCanada Forums

Full Version: Replaced Engine, Cooland Hose Problem!
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
i replaced the engine in my focus, i have a crappy little quick sketch i need someone to look at please, i have 3 hose spots, but 4 hose ends??!?!?!

the #3 and #2 i forgot to put on but i think thats where they need to be?!

please help.. thanks

[Image: scan0001.jpg]
spi engine, so really not sure, but on the zetec and off the top of my head...

-one goes to the water pump
-4 go to the coolant (small hoses)
-Thermostat housing, think theyres one main and another small one...
-Rad, I think has 3 hoses going to it

Thats off the top of my head so check those...
k, i only have 3 from the coolant, and i have 2 from the water pump.

I have one hose that splits into 2 hoses, thats where im most confused
howie321,Aug 3 2007, 03:50 PM Wrote:k, i only have 3 from the coolant, and i have 2 from the water pump.

I have one hose that splits into 2 hoses, thats where im most confused
[right][snapback]245672[/snapback][/right]
what about the thermostat housing?
i has 3, the rad, one i dont know where it goes, than another that goes to the rear of the motor, didnt take that one off tho im certain of that one