Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mbrp
#1
I think my mbrp resonator might be fuked cause at around 3000 rpm it starts buzzing like a chainsaw inside. Now how do I collect warranty without drivng to huntsville to show them the malfunction. was going to put on stock system but i can't find it at my parents house. so I need to ride the botched unit regardless.
Reply
#2
crawl under the car to see if any of the clamps came loose, if not, then you got a defective Rez. try calling them first, cus they might have a local shop do it for you,
My other ride is your Mom
Reply
#3
Is it remotely possible to F up a res? ;)
2000 ZX3: KW coil-over/IceMan/FC UPD/Megaflow cat-back /energy bushing all over/Ported TB/home make ground wires

260000km and counting.....
Reply
#4
[COLOR=blue][COLOR=blue][COLOR=blue]

I've checked it a few times and it's not the clamps it's internal. I tapped it with a hammer and it vibrates inside.
Reply
#5
Call Ed at MBRP's 1-800 number on their website and see what he wants to do.
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"

33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.

Daily driver 2: 2006 Subaru Legacy GT

COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Reply
#6
how long has it been installed for??
2005 ZX4 SOLD! ST; 1992 Mustang 5.0L S/C

[Image: lakemitchellsml.jpg][Image: burnout1sml.jpg]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)