Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Brake Lights Not Working
#1
Hey guys, leaving work tonight I noticed in the window reflection that my brake lights aren't working at all. Tail lights turn on, signals work properly, but nothing lights up when I step on the brake pedal.

Is there an easy answer for this? It's too dark to start looking tonight, but I don't want to be driving around with no brake lights. I've had a similar thing on an old chevette where there was a switch hooked up to the pedal, does the Focus use a similar device?

Any insight would be much appreciated.
Reply
#2
guilty,Oct 9 2007, 01:43 AM Wrote:Hey guys, leaving work tonight I noticed in the window reflection that my brake lights aren't working at all.  Tail lights turn on, signals work properly, but nothing lights up when I step on the brake pedal.

Is there an easy answer for this?  It's too dark to start looking tonight, but I don't want to be driving around with no brake lights.  I've had a similar thing on an old chevette where there was a switch hooked up to the pedal, does the Focus use a similar device? 

Any insight would be much appreciated.
[right][snapback]250448[/snapback][/right]
1 of the filaments is broken are mostlikey broken in the Bulbs...
Hit CT grab a new bulb and check... Very easy fix if its that.
Reply
#3
could be a few issues, these are the ones it could be, and to check for.

1. fuse under the dash might have blown
2. fuse under the hood might have blown
3. tail light bulbs (ie. one side of the filaments is gone) might have blown, but you would have noticed it with a high speed flashing of the turn signels, or or loss of light when braking.
4. the plunger under the brake might have come loose
5. broken wire in your wiring loom in your trunk area, would happen if you had missing tirm / custom wiring for aftermarket tail lights.
I was the only member on this board with a Yellow Focus Sedan, and a 2002+ Euro Facelift on a sedan.
Reply
#4
Frost__2001,Oct 9 2007, 07:59 AM Wrote:could be a few issues, these are the ones it could be, and to check for.

1. fuse under the dash might have blown
2. fuse under the hood might have blown
3. tail light bulbs (ie. one side of the filaments is gone) might have blown, but you would have noticed it with a high speed flashing of the turn signels, or or loss of light when braking.
4. the plunger under the brake might have come loose
5. broken wire in your wiring loom in your trunk area, would happen if you had missing tirm / custom wiring for aftermarket tail lights.
[right][snapback]250457[/snapback][/right]

Start checking these. when my brake lights went out the 1st time, it was because in the area where the wires are always folding (hatchback), the wires became exposed, and some were severed. I had to rewire all the wires.
[Image: ncclogo.jpg]
Reply
#5
If none of your brake lights are working (including the centre one) and both turn signals are working , then it is not the bulbs.

What Flo says below started me thinking that there might have been a recall for a wiring issue like that ... ringing a belll anyway.


Flofocus,Oct 9 2007, 08:33 AM Wrote:Start checking these.  when my brake lights went out the 1st time, it was because in the area where the wires are always folding (hatchback), the wires became exposed, and some were severed.  I had to rewire all the wires.
[right][snapback]250460[/snapback][/right]
2008 Fusion SEL MTX - DD1 * 2009 Fusion SEL - DD2 * 2007 Focus ZXW - R*I*P * 2004 Focus ZTW CD Silver - sold * 2004 Focus ZTW Black - sold * 2003 Focus ZTW Black - sold * 2001 Focus ZTW Gold - sold * 2000 Focus SE Wagon (ZTW option) - Black - sold * 2000 Focus SE Wagon (ZTW option) - Gold R*I*P

2003 Focus ZX5 infra-red Track Rat - R*I*P
2003 ZX5 CD Silver Track Rat - retired, but still in the driveway


New track rat: 2000 ZX3, Atlantic Blue * JRSC with lots more to come

* New Zetec crate motor - NFG - thanks Topspeed *
Reply
#6
As for the plunger under the brakes, when mine was messed up, I had people telling me my brakes wouldnt turn OFF. <_<

Yeah, Ive been threw it all with my focus. :ph34r: :lol:
[Image: ncclogo.jpg]
Reply
#7
Transport Canada Recall Number: 2000302; Units affected: 9,815

2000: On certain vehicles, the decklid wiring harness may fatigue and develop broken wires in the bend area of the wire harness in the grommet on the decklid. This may occur due to a rigid vinyl sleeve that is located at the bend point. Broken wires could result in either a loss of individual lamp functions, or in the case of a short that causes a fuse to open, in the loss of stop lamp or tail lamp function. Correction: Decklid wire harness will be replaced with a wire harness that has a longer, more flexible sleeve.

Flofocus,Oct 9 2007, 09:49 AM Wrote:As for the plunger under the brakes, when mine was messed up, I had people telling me my brakes wouldnt turn OFF. <_<

Yeah, Ive been threw it all with my focus.  :ph34r:  :lol:
[right][snapback]250476[/snapback][/right]
2008 Fusion SEL MTX - DD1 * 2009 Fusion SEL - DD2 * 2007 Focus ZXW - R*I*P * 2004 Focus ZTW CD Silver - sold * 2004 Focus ZTW Black - sold * 2003 Focus ZTW Black - sold * 2001 Focus ZTW Gold - sold * 2000 Focus SE Wagon (ZTW option) - Black - sold * 2000 Focus SE Wagon (ZTW option) - Gold R*I*P

2003 Focus ZX5 infra-red Track Rat - R*I*P
2003 ZX5 CD Silver Track Rat - retired, but still in the driveway


New track rat: 2000 ZX3, Atlantic Blue * JRSC with lots more to come

* New Zetec crate motor - NFG - thanks Topspeed *
Reply
#8
Thanks for the suggestions guys. I'm going to go check all my fuses and wiring now..
Reply
#9
I checked the pedal switch and the plunger was definitely not moving when the pedal went down. The car is at my uncle's shop right now getting the new suspension installed so he's going to look at picking up a new switch while he's at it.
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Brake lights are out?? SL8RZZX3 4 2,744 06-08-2010, 01:29 AM
Last Post: Flofocus
  Brake Light On When Lights On Frost__2001 30 13,239 04-02-2008, 02:56 AM
Last Post: Frost__2001

Forum Jump:


Users browsing this thread: 1 Guest(s)