Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fiberglass Project #2
#1
Some of you may have seen how I put the gauges in my passenger side dash. How ever I was looking in the last issue of Modiified mag I think it was and they were featuring a Scion. So I decided to take that idea and make myself a gauge pod, like they did. I wish I could find a picture.

Just started tonight and well for sure take progress pics. Then for mounting Im planning on 3m tape then the brackets that are used for the gauges well hold the pod in place.

Some might pick up really fast what my plan is. I got 3 angle ring I plan on moulding onto this peice.

[Image: vl039.jpg]

[Image: vl041.jpg]

[Image: vl048.jpg]
Reply
#2
cool.
Reply
#3
I like that spot for gauges... Simon had his somewhere around there too... I'll see if I can find a pic
2000 Black ZX3
Blacked Out Head & Tail lights - APC Clear Turn Signals - 20% Tint All Round - K&N Filter - Cheap ass fogs that are brighter than my headlights - Clarion DXZ745MP - Jensen XA 4100 amp on Mobile Authority 200w 6x8's - Jensen 340w amp on a 12" Rockford Sub, custom enclosure - KYB GR2 Dampers - SHM Springs @ 1.5" - Brembo Cross Drilled Rotors w/ CVR Ceramic Pads - Silver Gauge Bezel - Focus Central 2-Piece Under Drive Pullies - 17 x 7 Rims by Fast Wheels mounted on 215/40/17's - Wings West W-Typ front lip - Coming Soon: Paint, Component Speakers (Spring 06)
Reply
#4
Looking Goood!
"Focus On The Road!"
I Love My Liquid Grey 2007 Focus ZX3 SE

Next: tint, front & rear bumpers...
Reply
#5
that looks awsome jay! Can't wait to see end results (which i'm sure will be good)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)