Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Emission Time
#1
well it's that time again for emissions I know the car will pass with no problems but the problem is I got not cat converter.
I just wanted to know if any of u guys who have a focus sport race header what kind of cat are u using??

I had one on my old flex pipe but I guess it was to small becouse it melted away.

I'm looking for a performance cat since I got SC installed now.

thank for ur help or ideas
B&G coilovers, Kamakazi headers,focus sport exhaust, 2.5 custom flex pipe, 18" oz rims, 65mm throtle body,ZX3 tuning custom cams,powerworks SC,spec 3 clutch,clutchnet 11lb flywheel,Eibach swaybar package,fs front lower stress bar,fs rear strees bar,svt big brake kit,quife diff,4.06 gears.(2012 plans FR head, 19lb boost & full engine rebuild) Good bye Escape hello 2012 focusBig Grin
Reply
#2
Get one welded in somewhere in your exhaust system. I think magnaflow makes one that any exhaust shop should be able to put in for you.
Current
09 F150 SCREW 4X4 XTR

Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads

Reply
#3
We have a trubenz 2.25". Works great. But you need time to get it here.
And we still don't pass the test. Without a little help. :D
TEAM PITA Don't settle for a wannabe, only accept the real deal.

One day I will rule the world. For now, I have to settle for this place.
Reply
#4
You wont pass if you have not cat.
[Image: ncclogo.jpg]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)