Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cyl.head
#1
does anyone know power # for a ford racing head?
focus sport gives 160hp & 150tq with porformance exhaust,intake and 91 octane.
B&G coilovers, Kamakazi headers,focus sport exhaust, 2.5 custom flex pipe, 18" oz rims, 65mm throtle body,ZX3 tuning custom cams,powerworks SC,spec 3 clutch,clutchnet 11lb flywheel,Eibach swaybar package,fs front lower stress bar,fs rear strees bar,svt big brake kit,quife diff,4.06 gears.(2012 plans FR head, 19lb boost & full engine rebuild) Good bye Escape hello 2012 focusBig Grin
Reply
#2
I have also been told that you can get 150+ hp at the wheels with their cylinder head, exhaust, intake, TB, and Cam gears. Sean Hyland was going to do timing on my car to get results like this if I had bought a head from him, but the labour rate for his shop is like $125-$150bux per hour, and well, I didn't want to spend upto 6-8 hours on a dyno AFTER buying the head....lol.

Also, I have been to other websites besides FS, and they also reported the same sort of HP and TQ figures...guess with some cams, and a couple other peices, you could get closer to SVT stock crank HP figures without forced induction...
Bleeding Ford Blue again...
Reply
#3
In retrospect though, after all the time and money spent on building up the engine with NA parts, you could just spend a little bit more and get FI anyways...lol

Bleeding Ford Blue again...
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)