Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Slight Rubbing Noise
#1
I have noticed in the past 3 weeks a slight rubbing noise form. It's defined enough for me to hear when I'm driving between rows of cars in a parking lot and the sound has something to bounce off of. Sounds to be coming from the drivers side wheel well. It happens at various speed depending on how fast I'm driving. I'm left to assume something is rubbing at a certain point on the rotor. On looking at it, I can't see anything. I'm assuming that it might be a warped/bent rotor, but I'm not entirely sure. Any ideas?

How much (if it is the rotor) would I be looking at for a set of blank rotors and pads? thanks
2000 Black ZX3
Blacked Out Head & Tail lights - APC Clear Turn Signals - 20% Tint All Round - K&N Filter - Cheap ass fogs that are brighter than my headlights - Clarion DXZ745MP - Jensen XA 4100 amp on Mobile Authority 200w 6x8's - Jensen 340w amp on a 12" Rockford Sub, custom enclosure - KYB GR2 Dampers - SHM Springs @ 1.5" - Brembo Cross Drilled Rotors w/ CVR Ceramic Pads - Silver Gauge Bezel - Focus Central 2-Piece Under Drive Pullies - 17 x 7 Rims by Fast Wheels mounted on 215/40/17's - Wings West W-Typ front lip - Coming Soon: Paint, Component Speakers (Spring 06)
Reply
#2
have you checked the fender/CV boot, etc? a visual inspection might yield something simple, like a cane or a walker that got caught up in there....
Contribute to focuscanada.net's future!

Donations of $20 and over get a custom title!







Reply
#3
darkpuppet,May 19 2004, 10:00 PM Wrote:have you checked the fender/CV boot, etc? a visual inspection might yield something simple, like a cane or a walker that got caught up in there....
Yeah, I was wondering about that when I ran over that old lady and her hop-along gear.
2000 Black ZX3
Blacked Out Head & Tail lights - APC Clear Turn Signals - 20% Tint All Round - K&N Filter - Cheap ass fogs that are brighter than my headlights - Clarion DXZ745MP - Jensen XA 4100 amp on Mobile Authority 200w 6x8's - Jensen 340w amp on a 12" Rockford Sub, custom enclosure - KYB GR2 Dampers - SHM Springs @ 1.5" - Brembo Cross Drilled Rotors w/ CVR Ceramic Pads - Silver Gauge Bezel - Focus Central 2-Piece Under Drive Pullies - 17 x 7 Rims by Fast Wheels mounted on 215/40/17's - Wings West W-Typ front lip - Coming Soon: Paint, Component Speakers (Spring 06)
Reply
#4
Raine,May 19 2004, 11:28 PM Wrote:
darkpuppet,May 19 2004, 10:00 PM Wrote:have you checked the fender/CV boot, etc?  a visual inspection might yield something simple, like a cane or a walker that got caught up in there....
Yeah, I was wondering about that when I ran over that old lady and her hop-along gear.
oHH YEAH!!

Try dislodging a wheelchair after you hit it going 90k..

Thats a problem
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  screeching/rubbing noise when releasing clutch arpaul15 11 9,793 10-23-2011, 02:07 PM
Last Post: arpaul15

Forum Jump:


Users browsing this thread: 1 Guest(s)