[Canadian ST]

Well I want to debadge my focus next week and was wondering what tools I needed? I want a cleaner look too. Any tips would be helpful.

Thanks :D

[mo_focus]

do a search, i'm sure there are lot of usefull info on it.

Some ppl use dental floss and hair dryer. others use heat gun.

Myself, i was at a gas station and my car was sitting in the summer sun, i played with it and it just came off. I never did remove all of the letters, but just relocated the ZX3 so it would be right under the Focus sign.

[konafocuswrc]

floss, fishing wire, so and so..
there is tons of way to do..
and i also did udner the sun..

[focusonthis_88]

Dental floss and Heat Gun or Blow Dryer. Take about 10 minutes to do. After just buff it to remove all the excess glue and your good to go.

[Oscar The Grouch]

Here's the Link to my experience with removing the badges.

[euro_zx5]

Honestly, you can read 50k ways of doing this, they're all relatively the same. Some people suggest you heat the letters/glue up first and some don't. If it's a warm day and like said above, your parked in the sun, the letters should comes off no problem. I have used a credit card in the past, and then goo gone cleaned up the remaining glue no problem.

[Spinal]

i did it one day in the hot sun, took a cap from a aresol can and just worked at them lol. then rubbed off the rest of the glue with some varsol. came out good :lol:

[Mason]

Spinal,Oct 6 2007, 08:20 PM Wrote:i did it one day in the hot sun, took a cap from a aresol can and just worked at them lol. then rubbed off the rest of the glue with some varsol. came out good :lol:
[right][snapback]250310[/snapback][/right]

Super easy. Pull them off and use goo-gone to get the glue off.

[konafocuswrc]

or rub with your finger until you get blisters.. :D