Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hints On Debaging My Focus
#1
i decided to debag the rear of my focus....

i heard its pretty hard to get rid of the glue stuff that hold the letters....
any "cleaner" stuff that would work good and not leave those shades after?

Goo Gone maybe?

let me know
thanks
2002 Ford Focus ZTS (Gave it away)
125whp/129wtq
2006 Subaru Impreza WRX with JDM 6 speed
207whp/273wtq Innovative tuned on Mustang dyno (Stage 2)13.9@99mph
320whp/330wtq Innovative tuned on Mustang dyno (Stage 3)
352whp/360wtq Dynojet
13.3@106mph
2004 Ford F-150 Lariat
2008 Honda CBR600RR "Silver Bullet" R.I.P.
2009 Honda CBR600RR "To Punish & Enslave"
2001 Honda CBR F4i Stunt bike "Burn the Rubber, not your soul"
2013 China 90cc dirt bike
Reply
#2
i know somoene who used lighter fluid to get it off
Interior
Jvc headunit, , Kicker Zx 1000.1, 2 12" Kicker comp VR, Diamond plate floor mats

Power mods
FRPP spark plug wires, Volant CAI
Reply
#3
They say goo gone ive heard that quite often so that must work , just be prepared for elbow grease
Ford Focus SES ZX5
Blue Underglow, Clear Corners, Shorty antenna, vogtland springs , Rust Module,Truebendz 2.5 ss magnaflow and Fuzion 205/50/16 HRI's
TEAM DURATEC # 99
Reply
#4
just use wax compound to clean off the "gunk"
My other ride is your Mom
Reply
#5
well i just tried "Wax as you Dry" not sure if that will do anything but tried it anyway.....still some of that "glue" stuff on .....needs something that completly takes it off
2002 Ford Focus ZTS (Gave it away)
125whp/129wtq
2006 Subaru Impreza WRX with JDM 6 speed
207whp/273wtq Innovative tuned on Mustang dyno (Stage 2)13.9@99mph
320whp/330wtq Innovative tuned on Mustang dyno (Stage 3)
352whp/360wtq Dynojet
13.3@106mph
2004 Ford F-150 Lariat
2008 Honda CBR600RR "Silver Bullet" R.I.P.
2009 Honda CBR600RR "To Punish & Enslave"
2001 Honda CBR F4i Stunt bike "Burn the Rubber, not your soul"
2013 China 90cc dirt bike
Reply
#6
Goo Gone works the best... and it has a nice, fresh, lemony scent :)
Does a shorty anntena count as a mod?? Wink
2006 ZX5 UV red with SAP package

"Two things in life are infinite: the universe and human stupidity; and I'm not so sure about the universe"
Reply
#7
On my grand prix it was a heat gun and a piece of fishing wire
02' SONIC BLUE, SVTF #2686 OF 4788
K&N FIPK
SCT XCAL-2 POWERED BY STEEDA
SCREAMIN' DEMON COIL PACK & LIVEWIRES
STEEDA STRUT TOWER BRACE (SONIC BLUE)
STEEDA STS
STEEDA REAR POLY MOTOR MOUNT
DEI HEADER WRAP
MBRP 2.5" EXHAUST
EBC GREENSTUFF PADS
EBC SLOTTED AND DIMPLED ROTORS
RUSSELL STEEL BRAIDED LINES
EURO SVT RIMS 17" General Exclaim UHP
ALPINE H/U



Winter package includes Euro SVT RIMS with Nokian WR'S
Reply
#8
^^^yea, but its the rest of the stuff that stays on the trunk,,,
2002 Ford Focus ZTS (Gave it away)
125whp/129wtq
2006 Subaru Impreza WRX with JDM 6 speed
207whp/273wtq Innovative tuned on Mustang dyno (Stage 2)13.9@99mph
320whp/330wtq Innovative tuned on Mustang dyno (Stage 3)
352whp/360wtq Dynojet
13.3@106mph
2004 Ford F-150 Lariat
2008 Honda CBR600RR "Silver Bullet" R.I.P.
2009 Honda CBR600RR "To Punish & Enslave"
2001 Honda CBR F4i Stunt bike "Burn the Rubber, not your soul"
2013 China 90cc dirt bike
Reply
#9
Use fishing wire to get the letters off, then just peel the big chunks of glue off with your fingers and any of the residue that is left over use the goo gone on. Thats exactly what i did when i debadged the back end of my focus.
Current
09 F150 SCREW 4X4 XTR

Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads

Reply
#10
NikiterZTS,Feb 26 2007, 11:18 PM Wrote:^^^yea, but its the rest of the stuff that stays on the trunk,,,
[right][snapback]228302[/snapback][/right]

I used gasoline on a rag, then cleaned it right away with water and soap.
[Image: ncclogo.jpg]
Reply
#11
I use WD40 to remove sticker goo, works great.
Reply
#12
Flofocus,Feb 26 2007, 10:34 PM Wrote:
NikiterZTS,Feb 26 2007, 11:18 PM Wrote:^^^yea, but its the rest of the stuff that stays on the trunk,,,
[right][snapback]228302[/snapback][/right]

I used gasoline on a rag, then cleaned it right away with water and soap.
[right][snapback]228307[/snapback][/right]

definatly the tried and true method... race gas... rag (don't scrub hard!) and water then clay bar it and wax... like it was never there... accept that the paint under the emblem hasn't under gone uv degradation and it looks darker... at least on a black car... LOL I had the ricest vynle EVER on my ride.. you'd never no,,, lol lemme find a pick
[Image: forumsig.jpg]

I could List my mods.. my times and even my future mods here.. but there the same as yours.. with a little less conversation and a lot more action!
Reply
#13
Goo Gone works wonders for that.
'14 Escape 2.0t
2012 5dr Ti : Traded
Reply
#14
Use dental floss to remoce the badges.

Then goo-gone on a rag.

Presto!


a.
Reply
#15
I used a hair dryer to take mine off...it got the letters and adheisive plyable enough to peel off almost entirely.

Then, I used a small amount of Acetone on a rag, and wiped off an area a few inches LARGER away from where the letters were, along with where they were.

3rdly, applied liberal amounts of paste wax (turtlewax platinum) to the entire hatch, and blended in the areas...after about 3 coats, you would never know there had been a badge at all on it.

That's how I did it.

L8tz
Bleeding Ford Blue again...
Reply
#16
I did mine on a hot day (wait if you can) ............. came off real easy !! Used a little fishing line ........ then WD40 to get the excees off. In all took 5min !!
Strive for that moment when you're only a slice of pizza and a hooker away from paradise.
Reply
#17
well i got some Goo Gone at work today...lets see how it does
2002 Ford Focus ZTS (Gave it away)
125whp/129wtq
2006 Subaru Impreza WRX with JDM 6 speed
207whp/273wtq Innovative tuned on Mustang dyno (Stage 2)13.9@99mph
320whp/330wtq Innovative tuned on Mustang dyno (Stage 3)
352whp/360wtq Dynojet
13.3@106mph
2004 Ford F-150 Lariat
2008 Honda CBR600RR "Silver Bullet" R.I.P.
2009 Honda CBR600RR "To Punish & Enslave"
2001 Honda CBR F4i Stunt bike "Burn the Rubber, not your soul"
2013 China 90cc dirt bike
Reply
#18
GOO GONE Should work just fine. The wax I was talking about is not the quick detail stuff, its the paste stuff that comes in that can and you dab some of it on a soft cloth and rub it in a circular motion and it will clean off the goop.
My other ride is your Mom
Reply
#19
Flofocus,Feb 26 2007, 10:34 PM Wrote:
NikiterZTS,Feb 26 2007, 11:18 PM Wrote:^^^yea, but its the rest of the stuff that stays on the trunk,,,
[right][snapback]228302[/snapback][/right]

I used gasoline on a rag, then cleaned it right away with water and soap.
[right][snapback]228307[/snapback][/right]
This is what we do at work.

It works.
TEAM PITA Don't settle for a wannabe, only accept the real deal.

One day I will rule the world. For now, I have to settle for this place.
Reply
#20
I went the Debadged look once, but it looked lame on yellow. but I used a hair dryer and it just peeled right off, and then used a little nail polish remover to get the rest of the crap off.

then I did this with a few Euro Badges, including the European Focus Badge on the other side.. for those that don't know about it.

[Image: 000_0285.jpg]

Nick I still have a few " [Image: 000_0303.jpg] " badges left if you want one to replace the "ZTS" and "Focus" ones, since it seems like a few guys here in North America with the ZTS' like the Flight Badge alone on their car.
I was the only member on this board with a Yellow Focus Sedan, and a 2002+ Euro Facelift on a sedan.
Reply


Forum Jump:


Users browsing this thread: 9 Guest(s)