[Focus-SE]

My Haynes Car manual is sorta useless.. I need to work on my car but i dont know what hub nut size on the front end of my car to go out and by the correct spindle nut bit. The Work that needs to be done is the front end drive shafts.

anyone have a clue?

anyone have a factory 2000-04 manual?

[Focus-SE]

Focus-SE,Nov 16 2009, 04: Wrote:My Haynes Car manual is sorta useless.. I need to work on my car but i dont know what hub nut size on the front end of my car to go out and by the correct spindle nut bit. The Work that needs to be done is the front end drive shafts.

anyone have a clue?

anyone have a factory 2000-04 manual?
[right][snapback]297384[/snapback][/right]

Here's a picture of what I'm talking about. not sure if it's the Axle nut or the spindle nut.. but either way.. I don't know what size it is.

[Scorcher000]

I think its 30mm or 32mm, mostly 30mm

[Focus-SE]

Scorcher000,Nov 16 2009, 07:01 PM Wrote:I think its 30mm or 32mm, mostly 30mm
[right][snapback]297392[/snapback][/right]

yeah thanks.

Sorry if I come off a little vague.. I'm not entirely mechanically inclined.