Posts: 1,922
Threads: 97
Joined: Apr 2004
Reputation:
0
Just a question, I got a SCT chip here programmed for my mods and I haven't installed it yet cause (not much knowledge of chips) I haven't installed my UDPz yet but have them programmed onto my SCT.
If I install my chip right now before putting my UDPz in, is that going to cause a problem with the chip since it's programmed with my UDPz in mind?
Posts: 9,588
Threads: 529
Joined: Mar 2004
Reputation:
1
I'd say probably nothing too severe as my understanding of the UDP mod is that it spins your accessories slower to gain more horsepower (lower rotational mass of the pulleys and less drag on the engine itself due to less pulley to turn).
I was told to wait on my SCT adventures till the MBRP goes on as I'd need a reflash / set aside a tune to anticipate the increase in exhaust flow from the new system.
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"
33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.
Daily driver 2: 2006 Subaru Legacy GT
COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Posts: 770
Threads: 55
Joined: May 2003
Reputation:
0
I assume, it would just idle a bit too high, cuz usualy udp wreck your idle a little.
could be wrong, just ask meister, he should give you a straight answer since he has sct cred's.
meister@steeda.ca
------------------------------------------------
-1991 Nissan Pulsar GTI-R
-2002 Red SVT focus # 2262 - sold
-2000 silver ZX3 - sold
Posts: 140
Threads: 13
Joined: Jan 2004
Reputation:
0
It will be fine. No worries
Black 10th Anniversary Cobra Coupe
11.1 @ 122
550RWHP 511RWTQ SAE
Tuned by Paul Meister @ Steeda.ca
http://www.steeda.ca
------------------------------------------------------------------------------------
Hi, Guest
