FocusCanada Forums Technobabble The Basics Oil Temp Sensor Installation

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Oil Temp Sensor Installation
PerfectSaiyan Offline
Senior Member
****
Posts: 553
Threads: 52
Joined: Nov 2005
Reputation: 0
#3
05-01-2006, 11:38 AM (This post was last modified: 05-01-2006, 11:44 AM by PerfectSaiyan.)
hardk0re,May 1 2006, 12:36 AM Wrote:Put the sensor into  the block, via any of the two points (that I already told you).

See the top of the sensor how it is threaded, well find a nut that goes on it.  Then get a connector that fits nice in there and put the connector on the wire for hte sensor and put it over the threaded part, tighten the nut down and thats it...
[right][snapback]184263[/snapback][/right]


hey can you post the picture again so I can remember where it is? I am going ot jack up the car on wednesday and do it!


ps. what is a connector?
THE FOCUS IS GONE! THE LEGEND IS DEAD!

but hey, im still around.....
Website Find
Reply


Messages In This Thread
Oil Temp Sensor Installation - hardk0re - 05-01-2006, 10:36 AM
Oil Temp Sensor Installation - PerfectSaiyan - 05-01-2006, 11:38 AM
Oil Temp Sensor Installation - Phantom - 05-03-2006, 01:34 AM
Oil Temp Sensor Installation - focusracer - 05-05-2006, 01:33 AM
Oil Temp Sensor Installation - Phantom - 05-05-2006, 02:39 AM
Oil Temp Sensor Installation - Phantom - 05-05-2006, 03:08 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)