05-24-2006, 10:21 AM
replacing the studs is easy .. i think i've done just about everyone on my drums
all you need to do is take the drum off .. hammer out the old studs .. then apply alittle red loctite to the bottom of the new stud .. put it in the hole, and put a couple washers on it then the wheel nut .... and tighten it as much as you can till its pulled the stud all the way in
should only take 3mins per stud .. if that
all you need to do is take the drum off .. hammer out the old studs .. then apply alittle red loctite to the bottom of the new stud .. put it in the hole, and put a couple washers on it then the wheel nut .... and tighten it as much as you can till its pulled the stud all the way in
should only take 3mins per stud .. if that
Below Average Car Club