[nass]

schade,May 24 2006, 12:21 AM Wrote:replacing the studs is easy .. i think i've done just about everyone on my drums

all you need to do is take the drum off .. hammer out the old studs .. then apply alittle red loctite to the bottom of the new stud .. put it in the hole, and put a couple washers on it then the wheel nut .... and tighten it as much as you can till its pulled the stud all the way in

should only take 3mins per stud .. if that
[right][snapback]189095[/snapback][/right]

DO you remember if it is 42 or 47mm studs for the back??