07-27-2004, 04:47 AM
To fit an aftermarket deck inside with the factory opening you must get a kit. you can either get the Sony Focus kit = $$$$ metra kit or scosche... i think there are a couple others.
The 6.5's seemed to fit well... i just made a cutout of masonite. and mounted 2 of the midrange holes into the masonite and then the other 2 were drilled into the door. there was a bit of a clearance issue with the tweeter on an angle. it stuck out a bit too much. but we just warmend up the speaker grille a bit, bent it and it fit fine.
The focals and the avis arent in the svt yet, because im too poor/lazy to get the rest of my install together. RE subs, orion amp and my compustar installed again.
The 6.5's seemed to fit well... i just made a cutout of masonite. and mounted 2 of the midrange holes into the masonite and then the other 2 were drilled into the door. there was a bit of a clearance issue with the tweeter on an angle. it stuck out a bit too much. but we just warmend up the speaker grille a bit, bent it and it fit fine.
The focals and the avis arent in the svt yet, because im too poor/lazy to get the rest of my install together. RE subs, orion amp and my compustar installed again.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold