Hi, Guest
06-17-2006, 07:02 AM
I have a freshly rebuilt Zetec Short block with SVT rods and pistons in it.
probably the cheapest method of getting into a built motor...
SVT head gasket would get you down to about 9.5-9.8:1 comp which is fine for upto 15psi.
Hell a lot of SVT guys are going 18+psi on a stock bottom end!
Probably around $1100cnd shipped if you are interested in just the short block:
New rod and main bearings
new rings
back-to-square honed
polished crank
file-fit rings
SVT rods and pistons
installed and ready to go!
I can even make it a complete built engine with a ported head and all the bells and wistlers if you like...
probably the cheapest method of getting into a built motor...
SVT head gasket would get you down to about 9.5-9.8:1 comp which is fine for upto 15psi.
Hell a lot of SVT guys are going 18+psi on a stock bottom end!
Probably around $1100cnd shipped if you are interested in just the short block:
New rod and main bearings
new rings
back-to-square honed
polished crank
file-fit rings
SVT rods and pistons
installed and ready to go!
I can even make it a complete built engine with a ported head and all the bells and wistlers if you like...