08-04-2006, 07:56 AM
I am in between replacing them, I have the energy bushing sitting here while I try to figure out how to get the old one out(I have a set of used arm). I burn the rubber and inner ring out but I have no idea how to get the outter ring out of the arm. And I think I will find a shop to do the cutting for me, there is no way I can do it on my drive way with jack stand. Any idea how much it will cost?
And for everyone that want to order the bushing give New edge a call.
And for everyone that want to order the bushing give New edge a call.
2000 ZX3: KW coil-over/IceMan/FC UPD/Megaflow cat-back /energy bushing all over/Ported TB/home make ground wires
260000km and counting.....
260000km and counting.....