Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
St170 Install Completed
#1
Well, in an hour an a half, I finished the install of my new st170 lights. I drove to work tonight and I have to admit I like the improved low beams. I find where the high beams are more concentrated in front, it takes away from visibility on the sides of the road. However, I can see pretty darn far directly ahead of me.
The only thing I can say for future reference for anyone interested, is if you use the American grille, it may not fit properly. On the lights, there was a little plastic stub sticking out into the grill area. To remedy this, I took a small flathead screwdriver, and used a rubber mallet to break off these stubs. It broke clean. The grille then went into place perfectly.
Reply


Messages In This Thread
St170 Install Completed - vy_MR2 - 03-08-2007, 10:48 AM
St170 Install Completed - focusonthis_88 - 03-08-2007, 10:49 AM
St170 Install Completed - vy_MR2 - 03-08-2007, 10:51 AM
St170 Install Completed - paolo - 03-08-2007, 11:29 AM
St170 Install Completed - Frost__2001 - 03-08-2007, 02:36 PM
St170 Install Completed - SVT ZX3 - 03-09-2007, 01:56 AM
St170 Install Completed - guilty - 03-09-2007, 08:09 AM
St170 Install Completed - Frost__2001 - 03-09-2007, 11:30 AM
St170 Install Completed - ZX3TUNING - 03-11-2007, 04:29 AM
St170 Install Completed - Frost__2001 - 03-11-2007, 11:27 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)