[Frost__2001]

well I wired up my Euro Clock yesterday and it's actually weird seeing the flashing blue light there above the clock when the car is off... it's been almost a year since I switched over to the Euro Radio Bezel, I found this wiring direction for those that are concidering adding a European Interior Clock.

STEP 1: Connect the Black/Yellow wire from the clock with the Black/Yellow
wire from the Radio connector.(Ground)Pin 2 at the Radio connector

STEP 2: Connect the Orange/Black wire from the Clock with the Orange/Black
wire from the Radio connector(Lights switched +12 V)Pin 4 at the
Radio connector.

STEP 3: Connect the Green/Yellow wire from the clock with the Yellow/Green
wire from the Radio connector (+12V switched)Pin 3 at the radio
connector

STEP 4: Connect the Orange/Yellow wire from the clock with the Orange/Black
wire from the Radio connector (+12v at all times) Pin 1 at the radio
connector

STEP 5: Disconnect the Black/Orange wire from the hazard lights switch (pin 8
at the HLS connector) and connect it to the Black/Orange wire from
the clock. Remove the plastic pin from your hazard lights switch
before installing at the new bezel.

Oh and using the Photo diagram on the back of the clock that konafocuswrc posted will help you out Tonnes if your doing this.