FocusCanada Forums Canadian Focus Community Off Topic Birth Of A V8

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Birth Of A V8
laidman Offline
Senior Member
****
Posts: 699
Threads: 60
Joined: Aug 2004
Reputation: 0
#10
04-11-2007, 07:26 PM
the main problem to machiingin it all out of one solid block is that its not cost effective. You could make a diecast Aluminum mold, and mass produce the product for less than half it would cost in just machining alone
Website Find
Reply


Messages In This Thread
Birth Of A V8 - darkpuppet - 04-11-2007, 12:45 AM
Birth Of A V8 - Aka - 04-11-2007, 01:06 AM
Birth Of A V8 - laidman - 04-11-2007, 05:34 AM
Birth Of A V8 - 02SVTSEDAN - 04-11-2007, 07:56 AM
Birth Of A V8 - girard.k - 04-11-2007, 10:13 AM
Birth Of A V8 - laidman - 04-11-2007, 11:31 AM
Birth Of A V8 - D-Dub - 04-11-2007, 12:12 PM
Birth Of A V8 - Aka - 04-11-2007, 02:20 PM
Birth Of A V8 - ZED_not_zee - 04-11-2007, 03:27 PM
Birth Of A V8 - laidman - 04-11-2007, 07:26 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)