04-20-2007, 02:18 AM
You can WD40 the wires to dry them out (displace the water) and see if that works... sparkplug wires, coil to distributor cap wire that is.
Otherwise, visual inspection of the other wires (MAF, etc) is all that's needed.
Did you wash the engine or something?
Otherwise, visual inspection of the other wires (MAF, etc) is all that's needed.
Did you wash the engine or something?
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"
33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.
Daily driver 2: 2006 Subaru Legacy GT
COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.
Daily driver 2: 2006 Subaru Legacy GT
COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.