Well i got the new valve cover today that i had ordered off a guy from FJ. So with great excitement i decided to install it. Well it was at this point that i learned a very important lesson. Apparently there exists 2 different styles of zetec valve cover. Mine has 2 half circles that extend down to the block on the driver side. The cover i ordered, unbeknown to me, is flat across on that end.
I'm pretty sure there isn't anything i can do at this point, just an expensive lesson i suppose. And after doing some searching on the net i've seen pics of both valve covers on focus'.
Just needed to vent a lil bit, kinda disappointed to say the least.
I'm pretty sure there isn't anything i can do at this point, just an expensive lesson i suppose. And after doing some searching on the net i've seen pics of both valve covers on focus'.
Just needed to vent a lil bit, kinda disappointed to say the least.
Current
09 F150 SCREW 4X4 XTR
Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads
09 F150 SCREW 4X4 XTR
Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads