Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ignition Tumblers Fubar'd
#14
I tapped it a few times with a deadblow rubber mallet and it finally was able to turn so that I could start the car and take it home. The key is still sticky when trying to pull it out, but at least I can put it back in and start the car now. I'll keep the mallet in the car just in case it happens again.

Do I still need to buy a new ignition cylinder?
vintage 2000 malibu blue ZX3 ***SOLD***
2013 performance blue ST

TEAM P.I.T.A.
Reply


Messages In This Thread
Ignition Tumblers Fubar'd - Medicman - 06-01-2004, 05:00 AM
Ignition Tumblers Fubar'd - Paparoach - 06-01-2004, 05:27 AM
Ignition Tumblers Fubar'd - Medicman - 06-02-2004, 01:47 AM
Ignition Tumblers Fubar'd - naz - 06-03-2004, 10:20 AM
Ignition Tumblers Fubar'd - MAlby7 - 06-03-2004, 01:06 PM
Ignition Tumblers Fubar'd - silver02svtf - 06-03-2004, 01:15 PM
Ignition Tumblers Fubar'd - naz - 06-04-2004, 02:56 AM
Ignition Tumblers Fubar'd - silver02svtf - 06-04-2004, 01:15 PM
Ignition Tumblers Fubar'd - DD1 - 06-04-2004, 01:19 PM
Ignition Tumblers Fubar'd - dBlast - 11-30-2007, 10:57 AM
Ignition Tumblers Fubar'd - ZX5focused - 11-30-2007, 12:15 PM
Ignition Tumblers Fubar'd - snorcus - 12-01-2007, 06:35 AM
Ignition Tumblers Fubar'd - Frost__2001 - 12-01-2007, 12:25 PM
Ignition Tumblers Fubar'd - dBlast - 12-01-2007, 01:22 PM
Ignition Tumblers Fubar'd - ZX5focused - 12-01-2007, 01:37 PM
Ignition Tumblers Fubar'd - Scorpion - 12-01-2007, 05:39 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)