[COCHYN]

Here you go m8, these are crappy one's I took before I sprayed the brackets up. They look much nicer now, like they were meant to be there.

You cannot see these brackets after all the covers are back on the seat. As you can see, the one's on the driver seat are welded on (had to be done due to the height adjuster) whereas the passenger seat has been bolted on using the existing holes.

The difficult job was adjusting the seats so they don't slouch too far back or too far forward. As you can see from the last pic, their just right... :D

TROUBLESHOOTING

Be careful on how you mount the steel to the new seat when sorting out how to make the height adjuster work, coz lookin' at your seats I don't reckon u can make them work. So I advise you to adjust the brackets to your ideal ride height then weld them on, making sure you raise the back slightly or you will be driving in a very weird position. Look at picture 4, u can see that the bracket I've made has 2 nuts (excuse the pun! LOL), the lower 1 you can slacken then push the seat up and down from the back so u can adjust the brackets to their accurate horizontal measurement.

Cheers, good luck!