[naz]

Flofocus,Jun 4 2008, 12:25 PM Wrote:

naz,Jun 3 2008, 11:20 PM Wrote:can't drop the trans, driveshaft or exhaust no clearance to work on motor.. not sure its worth it since the jobs i mentioned are the ones where having a lift helps the most
[right][snapback]265866[/snapback][/right]

why not? If I can swap out trannies in my home garage on the cold ass floor, this will just give you that much more room to work. This will work.

If I had the cash for this, I would totally be calling and checking it out.
[right][snapback]265885[/snapback][/right]

if that was a WRX in the pic the front of the lift (that red part that scissors up) looks like it will be right under the middle of the transmission. i don't see how you could safely position a transmission jack using that style of lifter. i don't even thing you could install an aftermarket downpipe because you are blocked by the red scissor thing. it would almost be better to use a combo of ramps + jackstands

i guess in a fwd car with a small transmission that thing could work.

oh right.. focus forum..