Hi, Guest
03-14-2009, 05:14 AM
(This post was last modified: 03-14-2009, 05:15 AM by drunkinmonkey.)
so as some of you may no if you looked at my thread in the showrom i got a new cf hood....well i nstalled it today and it doesnt fit!! i went out just now to try and make it fit and i have come to the conclusion that the spring loaded pin on the latch refuses to make the hood latch close....i tried forcing the hood down to latch but its so close but i dont wanna get the hod jammed once i get it to latch...
so i guess my question is.is there anyway to over come this and way to remove that pin or move the latch somehow??
if you need pictars i can get some of what imtalking about
so i guess my question is.is there anyway to over come this and way to remove that pin or move the latch somehow??
if you need pictars i can get some of what imtalking about
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Instagram @o_so_slo