[BFocusSVT]

paolo,Feb 4 2005, 11:47 PM Wrote:no man, you have to add an increased resister to where the factory DRL resister is, and measure the voltage,  this requires trial and error.    Also, the DRL wire, that is tapped into the low beam through a bridge, must be cut, and tapped into the high beam instead,  this is where the schematics comes into play.
[right][snapback]83513[/snapback][/right]

Can you do this? If you do perhaps you can send me a step by step (with pics if possible) on how this is done? Thanks