Hi, Guest
08-30-2009, 10:43 AM
tetra,Aug 29 2009, 06:24 PM Wrote:Alright, so I bought some Autolite 104 coppers that I'm going to put in. I want to gap them at 0.055. I have the gapping tool that has the rings on it. Unfortunately it doesn't have 0.055 and goes from 0.050 to 0.060. How would you guys go about gapping it to 0.055?
I made it so that 0.050 goes through the ring no problem with a little bit of room, but yet small enough so the 0.060 goes in a bit, but cannot pass through. Is this the common way of doing this? Or must I buy a gapper with a 0.055 on it?
Thanks
[right][snapback]293507[/snapback][/right]
Personally I would simply go 0.05 ... but if you want to go to the next decimal place you need one of the round graduated gappers ... Like this one
2008 Fusion SEL MTX - DD1 * 2009 Fusion SEL - DD2 * 2007 Focus ZXW - R*I*P * 2004 Focus ZTW CD Silver - sold * 2004 Focus ZTW Black - sold * 2003 Focus ZTW Black - sold * 2001 Focus ZTW Gold - sold * 2000 Focus SE Wagon (ZTW option) - Black - sold * 2000 Focus SE Wagon (ZTW option) - Gold R*I*P
2003 Focus ZX5 infra-red Track Rat - R*I*P
2003 ZX5 CD Silver Track Rat - retired, but still in the driveway
New track rat: 2000 ZX3, Atlantic Blue * JRSC with lots more to come
* New Zetec crate motor - NFG - thanks Topspeed *
2003 Focus ZX5 infra-red Track Rat - R*I*P
2003 ZX5 CD Silver Track Rat - retired, but still in the driveway
New track rat: 2000 ZX3, Atlantic Blue * JRSC with lots more to come
* New Zetec crate motor - NFG - thanks Topspeed *