Hi, Guest
02-22-2005, 07:24 AM
Adam .. with the old wires on the car .. try spraying them with some water or windex or something of the sorts .. spray them while the car is running and see if you can notice any arcing going on .. that is a sure sign of a broken wire
if you do need to change wires its a Great time to upgrade to a set of MSD or steeda wires .. i'm sure there probably cheaper or the same as factory wires.
not sure if SPI wires are the same as the Zetec
if you can and want to wait on doing your plugs/wires i'll be in north bay on the weekend of 7th of march and i'd gladly give you a hand. Otherwise its a fairly straight forward process .. just make sure when your putting the new plugs in that you start them off by hand and do them up hand tight insted of using a ratchet .. then once hand tight .. do them up with a ratchet
if you do need to change wires its a Great time to upgrade to a set of MSD or steeda wires .. i'm sure there probably cheaper or the same as factory wires.
not sure if SPI wires are the same as the Zetec
if you can and want to wait on doing your plugs/wires i'll be in north bay on the weekend of 7th of march and i'd gladly give you a hand. Otherwise its a fairly straight forward process .. just make sure when your putting the new plugs in that you start them off by hand and do them up hand tight insted of using a ratchet .. then once hand tight .. do them up with a ratchet
Below Average Car Club