FocusCanada Forums Technobabble Focus on Performance AEM Gauge installation question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
AEM Gauge installation question
Jmountney1 Offline
Senior Member
****
Posts: 897
Threads: 117
Joined: Sep 2008
Reputation: 1
#16
06-10-2010, 06:12 AM
(06-10-2010, 04:17 AM)hardk0re Wrote: flux + solder + adhesive coated heat shrink tubbing - anything less is just cheaping out, you may aswell use masking tape.

2nd that. deff wasting your time with any thing but soldering them.

but connectors may work but they are not water tight and can corrode.
In Europe FORD is pronounced "\kwa-le-te\"

2008 f250 6.4 powerstroke/twin turbo/crew cab/XLT/4x4 Edge programmer, Cat and Dpf delete, mbrp exhaust. 650hp 850ft/tq.....
2002 red SVT sport'in European Appearance package rims, AEM cai, #4111 of 4788, ranger 12v plug cover, 4500k HID HI/LO, eibach springs, H&R 15mm wheel spacers. sold Sad
2000 yellow zx3 sold
1994 mazda mx3 sold
1992 ford festiva (RIP)
Find
Reply


Messages In This Thread
RE: AEM Gauge installation question - Jmountney1 - 06-10-2010, 06:12 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)