[scottmcleod]

(06-24-2010, 03:21 AM)Drivesthebeast Wrote: Yes he did...consult his 2nd picture from the top. He got lucky...ususally heat guns are too hot and blister the covering before it's 100% complete...

I was using the heat gun far back, and casting a wide "wave" of heat across my work area (on the low setting, too...). Got burned once or twice on the fingers, but it worked quite nicely. The material can take a LOT of heat before melting/burning. Many of the videos online of the 3M qualified installers and trainers use heatguns.

My biggest mistake though was not using glue in the right places. This was a challenging piece to start with, and I've learned my lessons. I will be stripping it and starting over in a week or two, for a more permanent install.

Thanks for the view :-)

---

Also, I'm going to get a tool that my friend was using today, and if it helps with those pesky corners, I'll post pics. ^_^