03-01-2005, 12:51 AM
Burnin21,Feb 28 2005, 09:08 AM Wrote:Hey guys,
I'm building a custom intake manifold (looks like the sheet metal intake from SHM) but I can't figure out how to get my stock one off. Me and my buddy were poking around for about 1 hour and 1/2 and I only managed to find to screws on the top. Do I have to get under my car to do this? Anybody have any sugestions that have taken their header off before? The reason I need to take it off is to get the dimentions for the flange I will be building and eventually the dimensions for the rest of the manifold.
[right][snapback]90089[/snapback][/right]
Maybe take a look at the Jackson installation instructions, they go through removing the stock one in there....