[Jmountney1]

my zx3 did the same thing but it was one of the springs in the clutch plate exploded lol. i still needed a new clutch and to make matters worse for some reason we undid one of the power steering lines going into the rack and it just snapped (wass varry rusty)

this is for you 2000 zx3? if it were 05 up i have a clutch you could of had.

(03-23-2011, 01:37 AM)NOS2Go4Me Wrote: So.... last Friday, was driving the g/f to work. Took a corner, went to shift from 2nd to 3rd and... no clutch. As in no disengage. Hmm.

Car rolls to a stop. Clutch pedal moves fairly freely to the floorboard. Can't grab a gear. Shut off engine, grab 1st... car doesn't roll. So clutch is perma-engaged. Pumping clutch yields small dribbles of fluid under the trans. Cursing ensues.

Call tow truck, tow to g/f's step-dad's garage a few KMs away. They inspect and tell me that my slave cylinder is likely gone. Also tell me that my clutch is likely "ruined" due to fluid leakage all over it. WTF?

Also, am told that front pass. wheel bearing is almost gone. That's funny, it was solid in Sept and Stan told me they were less than 2 years old. *puzzled*

Anyhow, had the car towed back home as the shop said it was going to be minimum $500 to attempt to fix (parts, etc) and possibly more than $1000 if the clutch is toast. Uhm, no. Will do stage 2 clutch, LSD and flywheel at that point if need be.

So... how much of a bitch is it going to be to check on this situation? I have hydraulic jacks and jackstands ready to go, along with a myriad of sockets, wrenches and a new impact gun.