Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
WuNgUn's one-man tranny install!
#1
Yeah, all by myself...finally got the sucka up and bolted in...

Here is my custom made shifter busging installed...

[Image: HPIM2116.jpg]

So basically, what I did was plop the Getrag into a milk crate, with the car up in the air, and slid it into position...

[Image: HPIM2117.jpg]

I carefully jacked the car down to get a better alignment...

[Image: HPIM2118.jpg]

And wiggled and tilted and lifted it up into place...started a few bolts top and bottom to draw it in...

[Image: HPIM2119.jpg]

And that's it!!
Wasn't too difficult, but I worry that maybe with my wiggling and tilting, that I might of caused damage to the main seal, or the throw out bearing...? Scary thought..
Time will tell!
That's as far as I got when I broke the bulb in my trouble light!! Dammit!

Oh, and the custome shifter bushing installed and cable mounted...

[Image: HPIM2122.jpg]

I'm a little concerned that the one I've sold will be seriously difficult to install with the tranny still in the car!!!
Reply


Messages In This Thread
WuNgUn's one-man tranny install! - WuNgUnSVT - 09-04-2011, 04:10 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)