01-29-2012, 03:39 AM
(01-24-2012, 10:50 AM)MuskokaZX3 Wrote: I've got a question about the pass. Side motor mount... Is the middle part supposed to be soft? I mean squishy... Like I can push in on the rubber part in the middle and I don't feel any resistance? Any thoughts there guys?
Hi,
The middle part is squishy, but you should not be able to push without resistance. When I checked mine, I could actually push until I felt the metal surface at the bottom. It needed to be replaced.
Not a bad job, but a little harder than the online video made it look (harder to get everything aligned). Oh, plus that fact that the nuts on the motor end were 18 mm, not 19 mm as claimed. Had to go find an 18 mm socket (not part of most basic sets)
Bob the Duck Canuck