Hi, Guest
04-17-2012, 12:59 PM
(This post was last modified: 04-17-2012, 01:07 PM by drunkinmonkey.)
Thanks man. It's almost there but more sanding and some final testing and fitting then time for paint
For the gauge surround and the door gauges I would require the surround and door piece. Or at an additional cost I can tru to hit up the local scrap yard and make one. As for the a pillar I have a mock up. But you guys are responsible for hacking your stock a piller to run the wiring etc.
For the gauge surround and the door gauges I would require the surround and door piece. Or at an additional cost I can tru to hit up the local scrap yard and make one. As for the a pillar I have a mock up. But you guys are responsible for hacking your stock a piller to run the wiring etc.
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Instagram @o_so_slo