Hi, Guest
08-14-2012, 10:24 AM
Thanks again Ken,
Yeah, I agree that I want as much surface area as I can get on the spacers.
I just tried "persuading" the DS tie-down. Forget it! You can move the lower corner somewhat, but since the hitch side plate goes all the way up to the side of the frame rail, you would have to move that also. Obviously not going to happen.
I'll go back at it tomorrow. A rested mind helps.
Bob
p.s. the Reese 77114 is the same product as the HiddenHitch 60870, just with a different label. They are all made by Cequent Towing Products.
Yeah, I agree that I want as much surface area as I can get on the spacers.
I just tried "persuading" the DS tie-down. Forget it! You can move the lower corner somewhat, but since the hitch side plate goes all the way up to the side of the frame rail, you would have to move that also. Obviously not going to happen.
I'll go back at it tomorrow. A rested mind helps.
Bob
p.s. the Reese 77114 is the same product as the HiddenHitch 60870, just with a different label. They are all made by Cequent Towing Products.