FocusCanada Forums Canadian Focus Community Focus Talk Building my bottom end

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Building my bottom end
drunkinmonkey Offline
O SO SLO
*****
Posts: 2,344
Threads: 157
Joined: Jun 2008
Reputation: 3
#19
03-23-2013, 09:37 PM
I use stock. Haven't had an issue yet
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Find
Reply


Messages In This Thread
Building my bottom end - stupica1 - 03-21-2013, 01:31 AM
RE: Building my bottom end - drunkinmonkey - 03-21-2013, 01:47 AM
RE: Building my bottom end - stupica1 - 03-21-2013, 02:59 AM
RE: Building my bottom end - drunkinmonkey - 03-21-2013, 03:04 AM
RE: Building my bottom end - ZTWsquared - 03-21-2013, 06:44 AM
RE: Building my bottom end - drunkinmonkey - 03-21-2013, 06:46 AM
RE: Building my bottom end - stupica1 - 03-21-2013, 07:07 AM
RE: Building my bottom end - sonic_mikey - 03-21-2013, 09:10 AM
RE: Building my bottom end - hardk0re - 03-21-2013, 08:26 PM
RE: Building my bottom end - stupica1 - 03-21-2013, 10:02 PM
RE: Building my bottom end - hardk0re - 03-22-2013, 01:24 AM
RE: Building my bottom end - stupica1 - 03-22-2013, 02:20 AM
RE: Building my bottom end - drunkinmonkey - 03-22-2013, 02:42 AM
RE: Building my bottom end - stupica1 - 03-22-2013, 02:47 AM
RE: Building my bottom end - ZTWsquared - 03-22-2013, 12:49 PM
RE: Building my bottom end - stupica1 - 03-22-2013, 01:46 PM
RE: Building my bottom end - stupica1 - 03-23-2013, 11:51 AM
RE: Building my bottom end - adamzx5 - 03-23-2013, 12:20 PM
RE: Building my bottom end - drunkinmonkey - 03-23-2013, 09:37 PM
RE: Building my bottom end - hardk0re - 03-23-2013, 10:13 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)