FocusCanada Forums Canadian Focus Community From the Street My first build thread, 2000 ZX3 turned RS

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
My first build thread, 2000 ZX3 turned RS
MikkelRS Offline
Member
***
Posts: 180
Threads: 12
Joined: May 2013
Reputation: 0
#7
03-23-2015, 01:13 PM
   
The zetec block has 3 bolts line up on the 4cyl T5 bellhousing, so im probably just going to weld two blocks to the top 2 mount holes and make it bolt on. The only issue i see is the centering of the trans to crank (which i will measure), and the starter location and interference.

   
I got my intake flange welded up and ground down nicely. Im going to weld over another bead to make sure it sealed up later.

   
I may have to change my front brake setup to use these, 320mm audi S4 rotors and Mercedes S430 4 piston brembos. I think that may stop the car just about good and sexy Smile
Find
Reply


Messages In This Thread
RE: My first build thread, 2000 ZX3 turned RS - MikkelRS - 03-23-2015, 01:13 PM
RE: My first build thread, 2000 ZX3 turned RS - 02ztsian - 03-23-2015, 09:12 PM
RE: My first build thread, 2000 ZX3 turned RS - 02ztsian - 10-25-2015, 10:07 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  wrc rally replica build thread konafocuswrc 710 547,259 04-07-2016, 01:03 AM
Last Post: ANTHONYD
  Few new parts, possible build thread? jtdanks 40 26,352 05-11-2013, 09:49 AM
Last Post: jtdanks

Forum Jump:


Users browsing this thread: 6 Guest(s)