Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Won't run after new clutch + flywheel install
#18
Well I have found the problem . Sure enough I was correct . The crank ring is in the wrong position there is one bigger section that has to line up with the dot . It is not lined up . Here you can see the dot in the smaller section .....wrong

Here is the bigger section with no dot .

So I'm gonna contact CFM , I would like some sort of compensation for all the work that needs to be reversed .


Here is the old one which is the correct way . I'm beyond pissed .


Attached Files Thumbnail(s)
           
2002 SVT Focus
Procharger @ 10psi , Clutch Masters Stage 3 Clutch,Stainless Borla Exhaust, Ebc dimpled + slotted rotors and brakes ,Russel Stainless brake lines , Koni adjustable shocks ,Eibach Sportline Springs , CFM short throw shifter , Euro Grill , CFM 65mm tb , Mach Headlights , MSD Coil ,SCT Dyno tune @ steeda , Volant Intake .  
-2003 SVT Wagon - Euro Conversion , currently retired
Svt side skirts , st170 front bumper , mach headlights , spax rear adj shocks , focus sport rear springs , volant CAI , Roof rack delete , Street edition Spoiler , MBRP exhaust , Eibach front swaybar , shorty shifter and lots more to come!                             .
2011 SES - daily driver will be modded soon .                                                                                                                                                        
Reply


Messages In This Thread
RE: Won't run after new clutch + flywheel install - 2000zx3sct - 06-20-2015, 09:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)