03-25-2005, 05:47 AM
yeloZX3,Mar 24 2005, 02:30 PM Wrote:the shift boot looks really good, i like....
is it exactly as this one?
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...1&category=6763
if yes, since i see there's a metal ring above the shift boot, can it still fit into our shifter with the reverse lockout? or modifying is needed?
[right][snapback]96236[/snapback][/right]
Ya it's the exact same one. I took that ring off (it's sewn into the stitching). The i turned the boot inside out and slid the top hole first over the reverse lockout. I grabed a zip tie and tied it where it's supposed to be. Then I flipped it right side up so the boot folds over the zip tied part and goes down to the ring. Hope that helps!
- Mike