[ANTHONYD]

02ztsian,May 9 2005, 09:36 AM Wrote:Chop the old one. It's easy. What I did is used an x-acto knife or a utility knife, cut the little rubber tip off by rolling it while holding the blade against the antenna. Then do the same rolling cut to make it as short as desired. Then take a drill bit probably was 1/8 or 3/16 drill out the rubber tip removing the old antenna renmants hold the drill bit in your fingers NOT in the drill,  roll and drill out. Bevel the edges of the cut down antenna with a file or sandpaper press tip over end and VOILA! Best thing is it still has the flexibility and you'll never snap it off.
[right][snapback]107258[/snapback][/right]

Or you can just heat the rubber tip up with a heat gun and it slides right off. :D