FocusCanada Forums Technobabble Focus on Performance It Is Finished And On The Road!

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
It Is Finished And On The Road!
ZX3TUNING Offline
Senior Member 1st Class
*****
Posts: 1,251
Threads: 84
Joined: Jun 2004
Reputation: 0
#14
05-29-2005, 03:11 PM
here are some pics:

[Image: pw003.jpg]
[Image: pw004.jpg]
[Image: pw005.jpg]

i'll get some better pics up tomorrow!


here is what is required to fit the FMIC behind a 02+ euro bumper on a US spec Focus...
[Image: modify4pw.jpg]
you need to remove the vertical slats that hold the lower grill in place and trim back the sides on an angle to meet up with the bottome where about .75-1.25" needs to be trimmed back. you can retain the use of the lower grill if you trim the bottom retainer clips off and a small amount off the back bottome edge of the grill, not a lot as the grill can be pushed forward at the bottom to where the bumper was trimmed too!
Find
Reply


Messages In This Thread
It Is Finished And On The Road! - FociPhil - 05-14-2005, 10:07 AM
It Is Finished And On The Road! - meford4u - 05-14-2005, 10:14 PM
It Is Finished And On The Road! - Flofocus - 05-15-2005, 05:45 AM
It Is Finished And On The Road! - ZX3TUNR - 05-15-2005, 05:44 PM
It Is Finished And On The Road! - P-51 - 05-28-2005, 10:32 PM
It Is Finished And On The Road! - ZX3TUNING - 05-29-2005, 03:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)