Hi, Guest
05-30-2005, 05:08 AM
no you are cutting the bumper to fit the fogs, not the bumper to fit the grill.
you need to full opening lower grill for a car without fogs to do the install as per the instructions. doing it by the instruction you need to cut into the bumper on either side of where the stock fogs would go as per the templates provided. once cut you will notice there is a big gap between the standard grill with fogs. this is where the full opening grill comes into play, you will also need to cut that aswell! :unsure:
if you can fit them without cutting them then it might not be a bad idea but i'm pretty sure that is where you are having problems with the rad support.
let me kow how it works out or if you have any other questions! :)
once you get it done, you should be very happy with the results... just getting there is the problem. :blink:
you need to full opening lower grill for a car without fogs to do the install as per the instructions. doing it by the instruction you need to cut into the bumper on either side of where the stock fogs would go as per the templates provided. once cut you will notice there is a big gap between the standard grill with fogs. this is where the full opening grill comes into play, you will also need to cut that aswell! :unsure:
if you can fit them without cutting them then it might not be a bad idea but i'm pretty sure that is where you are having problems with the rad support.
let me kow how it works out or if you have any other questions! :)
once you get it done, you should be very happy with the results... just getting there is the problem. :blink: