[Flofocus]

Some of you may know, I was asking for some help in regards to my car mis-firing, feeling like it was running on 2 cylinders. I found out there was at least 2" of water floating around in my cylinders :blink: . I changed the plugs and wires, but it didnt get rid of my hesitation problem. Everytime I would take the car out and drive it it would seem fine at first, but if I hoped on the throttle it would hesitate, and sound like it was mis-firing. The car sounded like crap, I couldnt drive over 4Krpm because of this....

I then started searching here and FJ, a member by the name of Daniel_Bzx3 pointed me in the right direction. Thanks. :D

Heres what I found...



Thats the connector that plugs into your coil pack. Right in front of it, below.

So, I went and bought this.



Very easy install. Requires Wire cutters, Soldering iron, some solder, electrical tape, lighter/heat-gun/hairdryer for the shrink rap. The package comes with instructions also. Cost is just over $50.00 with taxes. Some here can probably get it cheaper.

The new connector is def a lot more beefier, the wires arent as flimsy as the old one. I'll snap some pics and update later.