Chromey,Oct 8 2005, 07:50 AM Wrote:Yes the gauge came with a Brass Fitting thats Suppose to Tap into the Block I assume.
The Other howtos say use the Hole under the Distributor, I just wanna make sure that hole will still be the Correct hole for this application
[right][snapback]147586[/snapback][/right]
Yeah, you are supposed to use either 1/2" or 3/8" hoses depending on the fitting.
It is essential that you cut all three hoses and put the shorter hose into the A/F meter.
Anyways, you are supposed to cut or tap the wire # 54 for A/F and #50 for oil light/flow feed.
From the T.O. to the B-Lo. (D'Youville)
"Can I be da Joke Pimp?"
"Can I be da Joke Pimp?"