[Kool_ZX3]

OAC_Sparky,Oct 16 2005, 01:44 PM Wrote:

Kool_ZX3,Oct 14 2005, 10:02 PM Wrote:Ok another update, I goyt a code reader and was getting 2 codes on the KOEO test, maf sensor either to low or to high(mixture) forgot code number and oxygen sensor fault(due to maf out of whack)

then the engine on test i got one code it's number 411 cannot hold rpm during KEEO low rpm test

Any ideas?
[right][snapback]149203[/snapback][/right]

Pull the MAF sensor out and clean it, be careful not to break the resistor wires.
If you need pointers on how to do it PM me.
And check the harness like I said for any stretched wires. It was one of the very few probs I had, the dealer sells the pigtail kit, you solder and shrink wrap the new one on.
[right][snapback]149412[/snapback][/right]

well i cleaned the maf sensor twice, seems to have gotten better but still there. Cleaned the filter also and going to fine tune and adjust the new TPS to see how it goes then. It also said there could be a leak before or after the maf so i sealed eveything up and made sure everything is tight and going to try it later to see. The oxygen sensor seems to be ok just the maf is triggering it to adjust everything and everything goes haywire. Would a crappy coil or anything set a code, could it be a coil or anything like that?